I think I may use this technique for a headpiece…hmmmm?

Bead Shop Girl

GalaxysamplesTools Needed
Light-duty wire cutters
Chain nose pliers (2 pairs are helpful)
Hypo-Tube cement

Materials Needed For a 7″ Bracelet
1 1/2 yards .5mm leather
1 foot 3mm rolo chain, cut into two 6″ lengths
7 inches 3mm rhinestone chain
Four 6mm 18 gauge jump rings
1 toggle clasp

This design is made by feeding leather through every other link of two chains using a figure-8 pattern. Rhinestone chain is “caught” in the middle by crossing the leather over both the front and the back of the chain, between the rhinestone links. When weaving the chain it is important to keep the leather loose so that it rests along the outside edge of the chain links.

picture1

Step 1: Attach a jump ring to the 1st link of each rolo chain using two pairs of chain nose pliers.

TIP: Notice how the links of the rolo chain are positioned so…

View original post 402 more words

Advertisements